Creative Headboards – First, mark the wall with a light pencil marks at the top of your mattress. Move the bed away. Second, lift your head at the right height so that the headboard above the mattress and brand centered between your wall. Use a level to make sure that your head is perfectly level. Light mark guide lines on your wall in pencil to indicate the top, corners and sides of your head.
Third steps to link a homemade creative headboard is wall studs, each 16 inches on center so you need at least three available. Use your level to draw a slight vertical line at each of these locations. Draw a horizontal line in all of your vertical lines. Fourth, fit the bottom of your brackets flush to the wall, screw in studs with a screwdriver power. Fifth, the location of your flush mounts on the back of your head mark by placing the head on your side guide marks and the battlements of the wall, exposing the it that you have installed on the wall. Mark the back of your head at each installation location.
Sixth, measure the location of the flush mounts from the top pencil guide to the mounts on your wall. This measurement transfer to the back of your head. Use your marks at the top of the flush mounts screw into the back of the head end. Seventh, slide creative headboards from the wall using your hand marks as a guide. The flush mounts will unite and hold the head tightly against the wall.
12 Link A Homemade Creative Headboard Photos